quote:

---

Originally posted by slick379

right now it is a 8 ride show, wheel,pus,coaster,slide,sizzler,combo,cars,mgr two food wagons few games

---

Got a website up?

right now it is a 8 ride show, wheel,pus,coaster,slide,sizzler,combo,cars,mgr two food wagons few games

spots are the easy part the help and the dot is the hard how big is your show

i started a small show, it was not to bad hard part is finding spots.as far as dot goes know the law better than them and you can get out of most jams as long as trucks and drivers are up to par

You can work on my show

---

quote:

---

Originally posted by massachusettsman

Hi if I was to start a small show would this be a good start
King Kiddie Swing 2500$
Castle Mania type ride 5500$
King Helicoptar 12000$
Go Forth F-80 7500$
Hampton Combo 5000$
Watkins Tempest 15000$
Garbrick Wheel 9000$
King Frolic 9000$
Garbrick Merry Mixer 8000$
Popcorn Cart 1800$
Hot Dog Cart 900$
Soda Lemonade Cart 4000$
Skee Ball Trailer 10500$
Hi-Striker/Baloon Pop 1000$
Rope Ladder 1000$

All this doesnt include power tickets help spots etc.

---

You're Killing Me, Harry !!!

---

im not extremeley knowledgeable about how to fix or repair the rides, but dont most midways have a mobile shop? Even our small sized midway has a shop but they are also local and a 20 minute ride to their winter quarters makes it easier as well.

quote:

---

Originally posted by stickjoint

quote:

---

Originally posted by Pinetar

stickjint sez:

sizzler motors just go down, then you got a bum sweep, /quote]

The hyd. motors are an easy fix in the field, you just need the talents to repair them.

---

ok so tell me with out being pinetar, how are you going to fix one in the field, disconnect the hoses unscrew the 4 bolts take it out and run it to a shop real fast???? then put the bolts back on connect the hoses back to the motor and bang your in biz, or can i just adjust it while it's on the arm, just asking a serious question, as i would like to know.

---

quote:

---

Originally posted by with-it

quote:

---

Originally posted by Skywheelrider

quote:

---

Originally posted by massachusettsman

what has this been posted before[?]

---

Yeah, I post it about once every six months. LOL

---

FTFY

---

Uh, sure. Actually, I cannot recall ever posting a topic like this, especially in the last six months. That's the territory of folks like Rainbow Ben, Predator Rocks, etc.

---

quote:

---

Originally posted by Skywheelrider

quote:

---

Originally posted by massachusettsman

what has this been posted before[?]

---

Yeah, I post it about once every six months. LOL

---

FTFY

REM the hoses, pull off the plates, inspect and replace from spare parts while on the ride.

The inside is basic. If you want a real challenge, pull a Reverchon Poclain hyd. piston motor, replace a blown seal. The problem is the many pistons go in at an angle and not all at once.

I would set it on the office platform and open it up. The ride would run fine with 3 of the four motors but not at all with 2 on the Himi.

it has been awhile, perhaps it is not necessary to pull the hoses. I would keep old motors and use parts from them also.

---